19  Uninstalling the T.O.V.A. Hardware

To uninstall the T.O.V.A. hardware, simply do the opposite of the instructions above in Installing the T.O.V.A. Hardware (section 15).

If you have the EAV (External A/V ) hardware setup, you may disconnect those connections first:

1. Unplug the T.O.V.A. video cable from your computer’s VGA port.
2. Unplug your monitor’s video cable from the T.O.V.A. USB device and plug it into your computer’s VGA port.
3. Unplug the T.O.V.A. audio cable from the audio jack on your computer.
4. Unplug your speakers’ audio cord from the T.O.V.A. USB device and plug it into the audio jack on your computer.

Once any EAV connections are removed, disconnect the rest of the hardware:

1. Unplug the T.O.V.A. USB cable from your computer’s USB port.
2. Place your fingers on the dimpled sides of the T.O.V.A. microswitch connector and gently pull it apart from the T.O.V.A. USB device .

This will terminate operation of the T.O.V.A. USB device .